A steel or diamond needle scratches the plate and pushes up a burr of metal along each furrow. The burr holds ink and prints as a soft velvety black line that wears down after a few dozen impressions.
Core thesis
A needle that scratches bare copper throws up a burr. The burr prints as a soft black line that no acid and no burin can make.
Design principles
Draw straight on the bare plate with a hard needle; no ground and no acid.
Keep the burr: do not scrape it off, because it holds the ink and makes the velvet edge.
Draw the darkest areas with dense, near-parallel lines, and keep the light areas open.
Wipe the plate with a thin film of ink left in the field, for a plate tone.
Expect the line to thin after 20–50 impressions, and number the edition on that count.
Combine with etching only when a firm line is also needed; keep the burr lines for the shadows.